From: Epplin John A <EpplinJohnA@jdcorp.deere.com>
Subject: COZY: firewall heat shield
Date: Sun, 7 Mar 1999 12:56:51 -0600 

I attached the fiberfrax with the recommended cement from Wicks last week.
Am about ready to put the AL in place.  A couple of us nuts made some
samples last fall of plywood-fiberfrax-aluminum composites.  We used the
fiberfrax cement on one and 3M product called Fire Barrier CP 25WB+ caulk on
another.  The fiberfrax cement adhered to the plywood OK but it does not
adhere well to the AL.  The 3M product was good enough that when we
separated the parts the fiberfrax failed before the adhesive.  The 3M
product expands significantly when heated in a propane torch flame, it  does
not burn at all.  It does soften with acetone, however it does not seem to
be affected by oil.  I intend to use it to adhere the AL to the fiberfrax.
Anyone have any experience with this product?

John Epplin   Mk4  #467

From: cdenk@ix.netcom.com
Date: Sun, 7 Mar 1999 16:17:02 -0600 (CST)
Subject: Re: COZY: firewall heat shield

I have fiberax under .012" stainless for firewall. THere wasn't any special adhesive back then, I used a few RTV beads to hold 
in place. The perimeter is caulked with polyurethane construction sealant that's oil and fuel resistant.

Date: Sun, 07 Mar 1999 17:48:14 -0800
From: "LCDR James D. Newman" <infaero@flash.net>
Subject: COZY: Re:  Firewall heat shield

Hi John and All,

> John Epplin wrote:

> I attached the fiberfrax with the recommended cement from Wicks last week.  Am about ready to put
> the AL in place.  <snip>  I intend to use it to adhere the AL to the fiberfrax.  Anyone have any
> experience with this product?

    FWIW:  I believe the firewall was changed to stainless steel over the Fibrefax in the Long-EZ
plans eons ago.


Infinity's Forever,

        JD

From: "Paul Stowitts" <CozyBldr@worldnet.att.net>
Date: Sun, 7 Mar 1999 21:16:46 -0800

My Mark IV plans called out aluminum but I recall stainless steel was
mentioned somewhere in the text.  Use stainless steel - aluminum does not
provide much protection in the event of a fire.

Paul Stowitts
Cozy Mark IV #200





>Hi John and All,

>> John Epplin wrote:

>> I attached the fiberfrax with the recommended cement from Wicks last
week.  Am about ready to put
>> the AL in place.  <snip>  I intend to use it to adhere the AL to the
fiberfrax.  Anyone have any
>> experience with this product?

>    FWIW:  I believe the firewall was changed to stainless steel over the
Fibrefax in the Long-EZ
>plans eons ago.


>Infinity's Forever,

>        JD

